- Home /
Question by
jackB · Jan 12, 2012 at 12:23 PM ·
particlesoptimizationparticle system
Mix Simulate in Local and World Space for Fire Effect
I want to create a realistic fire trail on my moving targets with my particle emitter.
Right now in either:
In Localspace: it looks the fire looks too stiff, but follows the enemy around.
In Worldspace: The flame is always behind the target.
I have considered having two particle systems, but because a lot of targets are going to be fired up :) I would like to only use one particle system for this, any method to do this this?
Thanks Thanks
Comment
Answer by Berenger · Jan 12, 2012 at 03:30 PM
I don't know about a simultaneous solution, but you could try to switch between local and world inside a coroutine with a given frequency. If the frequency is low enough and the emission high ebough, it might not be so bad a trick.