- Home /
Question by
muratrencber01 · Jan 18, 2020 at 01:59 PM ·
rotationjointhingejoint2d
How to Rotate Hinge Joint 2D Without Affecting the Connected Rigidbody?
Tried to use motor and limits, but neither of them worked, connected rigidbodies always rotating together like in the image. I want only the second part to move, how can I achieve this?
hjoint2d.png
(6.3 kB)
Comment
Answer by BluePyramid · Jan 18, 2020 at 04:59 PM
Technically, this is impossible as the bottom corner of the rectangle you are trying to rotate would dig into the ground. However, it may be possible to use constraints (located under your rigidbody 2d panel). Good luck :)